Install the hinge bracket with 3" screws provided



SEE DOORRICADE FEATURED IN THE WINTER 2016 SURVIVORS EDGE MAGAZINE

PAINTABLE BRACKETS SWING AWAY WHEN NOT IN USE

WON'T DAMAGE DOOR OR TRIM MOLDING

SOLID ALUMINUM BAR

Place hinge bracket at desired height  then pre-drill holes for 3" flathead screws

Your door is now secure!

Copyright © 2015 - DOORRICADE.COM

All Rights Reserved.

Place hinge bracket at desired height  then pre-drill holes for 3" flathead screws

Your door is now secure!

To install this product you will need:


  • A drill and a 1/8 inch drill bit.
  • A measuring tape and a pen or pencil to mark the holes to drill.

Important:

Make sure the swing away brackets are installed as labeled.
L - for left side facing   R - for right side facing


  • Begin by placing first swing away bracket on the door jamb just above the middle door hinge.  
  • Mark the holes through the swing away bracket.
  • Drill the four pilot holes.
  • Than install the swing away bracket using the four screws provided.
  • Install the second swing away bracket on the opposite door jamb, measuring the same height as the first from the ground.
  • Mark the holes through the swing away bracket.
  • Drill the four pilot holes.
  • Than install the second swing away bracket with the four screws provided.
  • Now swing the brackets forward and put the Doorricade bar in place.

OVER 80% OF BREAK-INS ARE THROUGH THE FRONT DOOR

Install the hinge bracket with 3" screws provided



LIGHTWEIGHT AND STRONG

Easy installation guide.